Xantech CB20 One Zone Connecting Block with Two Emitter Ports
Share Share Share Share Share

Xantech CB20 One Zone Connecting Block with Two Emitter Ports

Connecting Block Provides Link Between IR Remote and A/V Components
  • Connects two emitter ports and power supply to Xantech IR Receivers
  • 3.5 mm stereo mini jack for quick-connect IR receivers
  • Two 3.5 mm mono mini jacks with 470-Ohm resistors drive two single or two dual emitters
  • 2.1 mm coaxial power jack
  • Uses either the 781RG or 782-00 power supply


  • Details
  • Specs
  • Reviews
  • What's Included
  • You can now control your A/V components in another room using your standard IR remote controls, thanks to Xantech. The 1-Zone Connecting Block is an integral part of Xantech's IR repeating system, which sends IR signals over unshielded 3-conductor inter-room cable (sold separately). Any IR receiver is required, sold separately, as are IR emitters, which attach to your components, delivering your IR signals. The 1-Zone Connecting Block (1 Emitter Out) provides a low-cost means of connecting Xantech IR receivers to two single or dual emitters and a power supply. The 1-Zone Connecting Block has two inputs: 12v power and a 3.5mm stereo mini jack, which will accept any Xantech IR receiver equipped with a 3.5mm stereo mini plug, such as the Dinky Link IR Sensor (sold separately). This connecting block features two 3.5mm mini jack outputs for emitters. Power for the CB20 1-Zone Connecting Block is supplied through its 2.1mm coaxial power jack for Xantech's 12-Volt Regulated Power Supply, (sold separately).

  • Specifications

    Manufacturer.: Xantech
    Xantech Product No.: CB20
    UPC: 042777300082
    Dimensions: 2 1/8" x 1 1/4" x 3/4"
    Inputs: 12v DC, 3.5mm mini plug for IR receiver
    Outputs: 2 3.5mm mini jacks for emitters
    Power Requirements: 12 V

  • 1 Review

    Review of 8192d Review by BRADLEY
    Review of 8192d

    not compatible with Dinky Link IR rcvr

    Posted on 1/4/2009

    Leave a Review

    Only registered users can write reviews. Please, log in or register

    • 1x - Xantech CB20 Connecting block
    • 1x - Mounting tape
    • 1x - Instructions

Please wait...