Sensaphone FGD-0027 Humidistat Indoor Humidity Sensor - Normally Closed or Normally Open

Detect High or Low Humidity Levels
  • Works with Sensaphone 400, 800 and Web600 controllers
  • Sensaphone Contact Series sensor
  • Powered via 110VAC hardwired connection
  • Can function in a Normally Closed state to detect too high a humidity level
  • Can function in a Normally Open state to detect too low a humidty level
  • Humidity range is 10% to 60% relative humidity (RH)
  • Sends an alarm trigger to Sensaphone controller when normality level changes
  • Multiple humidity sensors can be wired to a single input - in parallel if Normally Open, in series if Normally Closed.
  • Must be hardwired to a Sensaphone controller


  • Details
  • Specs
  • Reviews
  • Manuals
  • What's Included
  • The Sensaphone Sensaphone FGD-0027 Humidistat Humidity Sensor enables you to remotely receive notification when humidity levels raise or lower on your property via a Sensaphone 400, 800 or Web600 remote monitoring system controller. It will send a signal back to the Sensaphone controller when humidity thresholds (high or low) have been exceeded. The Sensaphone controller can then be programmed to immediately send a notification out so you can know the instant there is a change. The Humidistat Humidity Sensor is requires the use of a hardwired connection to a Sensaphone controller, and it can be wired for a single detector or multiple detector application.

    Wiring for connecting this sensor to a Sensaphone controller is sold separately. For one-off sensor applications 20 feet or shorter consider using a 20 foot length of 2 Conductor, 22-Gauge/AWG Interconnect Wire or if you are using multiple sensors it may be more effective to by a 1,000 foot spool of 2 Conductor, 22-Gauge/AWG Interconnect Wire.

  • Adding a Specifications Table (Basic)


     Brand  Sensaphone
     Manufacturer Part #  FGD-0027
     Operating Temperature  32° F to 95° F (-0° C to 35° C)
     Humidity Range  10% to 60%
     Connection  Hardwired
     Housing  Plastic
     Dimensions  4.5" x 3.0" x 1.7” (114mm x 76mm x 43mm)
     Sensor Series  Contact Series
     Normality  Depends on application - can be set to Normally Open or Normally Closed
     Number per input  Multiple. Wired in parallel if normally open. Wired in series if normally closed.
  • 1 Review

    Review of 7030 Review by GORDON
    Review of 7030

    Easy to install, we just started using the equipment so I don't hav emuch else to comment on at this time.

    Posted on 11/4/2009

    Leave a Review

    Only registered users can write reviews. Please, log in or register

  • •  Owner's Manual
  • •  1x - Sensaphone FGD-0027 Humidistat Humidity Switch

Please wait...