Radio Design Labs RU-VSX4 BNC Video Switcher, 4x1

Radio Design Labs RU-VSX4 BNC Video Switcher, 4x1

Connect 4 BNC Video Devices to a Single Output
  • Loop-through output from each Input
  • Vertical interval switching
  • Local or remote control
  • 10 MHz bandwidth, NTSC or PAL
  • Open-collector outputs
  • All solid-state switching



List Price: $391.39

Your Savings: $94.42

REWARDS: 296 points
  • Details
  • Specs
  • Reviews
  • Manuals
  • The RU-VSX4 is the ideal choice in most applications where four video signals need to be switched to a single output. The RU-VSX4 has two rear panel jacks for each of the four video bridging input stages. One jack is for the input signal; the other is a loop-through output of the source signal. If 75 Ohm termination of the input signal is required, the terminator (provided) is plugged onto the LOOP OUT jack. The output video signal is 75 Ohm back--terminated to provide unity gain into a 75 Ohm terminated input.

    The front panel features 4 high-reliability keyboard style pushbuttons with LED indicators corresponding to each video input. The LED indicator shows which video source is active. If the button for an active source is pushed, all video sources are turned off until the next source selection.

    A front panel LOCAL/REMOTE toggle switch activates either the front panel buttons or a rear panel connected remote control.

    • Input Impedance: 5k Ohm Bridging: 75 Ohm Line
    • Gain: Unity, 75 Ohm terminated Input; 75 Ohm terminated Output
    • Load Impedance: 75 Ohm
    • Outputs (5): 4 Loop Out from Input Signals; 1 Amplified OUTPUT
    • Operating Signal Level: 0.5 to 1 V p-p
    • Frequency Response: 10 Hz to 10 MHz (+/- 0.35 dB)
    • Noise: < -70 dB below 1 V p-p
    • Crosstalk: < -55 dB
    • Off Attenuation: > 65 dB
    • Differential Gain: 0.1%
    • Differential Phase: 0.3 degree
    • Connector Type: BNC, gold plated
    • External Control Inputs: Electronic or mechanical closure to ground, 1 mA
    • External Control Outputs (4): 50 mA, Open-collector to Ground
    • Power Requirement: 24 to 33 Vdc @ 110 mA, Ground-referenced
  • Leave a Review

    Only registered users can write reviews. Please, log in or register

Please wait...