Radio Design Labs RU-VDA4 BNC Video Distribution Amplifier, 1x4

Radio Design Labs RU-VDA4 BNC Video Distribution Amplifier, 1x4

Distribute One Signal to Four Devices Without Loss of Quality
  • Video distribution with 4 outputs
  • Adjustable gain amplification
  • Input LOOP OUT jack
  • Video 1 volt signal indicator
  • 10 MHz bandwidth, NTSC or PAL
  • 1/3 rack, high-density rack mounting



List Price: $289.85

Your Savings: $70.55

REWARDS: 219 points
  • Details
  • Specs
  • Reviews
  • Manuals
  • The RU-VDA4 is the ideal choice in most applications where video signals need to be distributed. Video inputs and outputs are made on the front panel via BNC jacks. Power connections are made using full-size barrier block terminals on the rear panel.

    The RU-VDA4 has two jacks in the input stage. One jack is for the input signal; the other is a loop through output of the source signal. The input stage is bridging. If 75 ohm termination of the input signal is required, the termination is plugged onto the LOOP OUT jack.

    Gain is user adjustable from the front panel. The GAIN potentiometer allows adjustment from -1 dB to +7 dB.

    This item requires a 24V power supply such as the PS-24K for operation.

    • Input: 1 kO bridging 75 Ohm line
    • Gain: -1 dB to +7 dB (0.9 to 2.25 V p-p, adjustable)
    • Outputs: 1 LOOP OUT from input signal; 4 amplified outputs
    • Output Level: 1 V p-p into 75 Ohm
    • Frequency Response: 10 Hz to 10 MHz (+/- 0.2 dB)
    • Noise: < -70 dB below (1 V p-p)
    • Output Isolation: > 40 dB
    • Differential Gain: 0.1%
    • Differential Phase: 0.1 degree (measured at 10% and 90 APL)
    • Connector Type: BNC, PHONO, or Type F
    • Power Requirement: GROUND-REFERENCED, 24 to 33 Vdc @ 60 mA
    • Ambient Operating Environment: 0° C to 55° C
  • Leave a Review

    Only registered users can write reviews. Please, log in or register

Please wait...