Leviton WSP05-080 LevNet RF 3-Wire Relay Receiver, 1,000 Watts

Wirelessly Automated Lighting Control the way you want it, Self-Powered and Off the Grid!
  • Zero power consumption
  • No additional wiring required
  • Reliable 315MHz RF Signal
  • Toggle style ON/OFF switching
  • Save up to 80% on energy consumption
  • Remote controlled
  • 240 Voltage



List Price: $99.64

Your Savings: $4.07

  • Details
  • Specs
  • Reviews
  • What's Included
  • The WSP05-080 LevNet RF Wireless Self-Powered 3-Wire Relay Receiver will remotely control lighting, HVAC and other loads up to 1,000 watts, located within 50-150 feet. The 3-wire relay can control one light or an entire group of lights. Control of the load is achieved by wiring this device in-between the load to be contolled and the power source. Any Levnet RF transmitter can control this receiver. Up to 30 transmitters can be programmed to control the WSP05-80. Wireless Radio frequency (RF) signals are sent to and from self-powered wireless receivers and controller modules to establish communication for programming and proper operation.

    The wireless relay receiver can mount in ceiling junction boxes, in-wall switch boxes, and wiring cavities. The receiver must be powered when programming. After programming, there is no need to worry about these settings being lost. Each device has a non-volatile memory, retaining all programming even after a power outage. The WSP05-80 receiver's sensitivity is decreased when in a learning mode this prevents unintentional associations between transmitters and receivers. Transmitters should be within 15 feet (5 meters) of the receiver while programming the two devices.

    Note: Relay receivers should be installed in a dry, In-door permanent location, yet still accessible for testing if needed. Also avoid installing in close proximity to any possible surrounding heat sources.

    For heavier loads or control of motors, see the 5-wire, 3,000 watt version of this relay receiver.

    LevNet - Enabled by EnOcean
    Self-Powered Wireless technology means no wiring is required. Leviton LevNet RF Self-Powered Wireless Solutions are easy to install and maintenance-free, utilizing no batteries and free to operate, saving ongoing labor and material costs while saving energy. LevNet RF devices offer zero power consumption and zero maintenance for recurring savings for the building owner. EnOcean technology allows energy harvesting LevNet RF Transmitters to operate indefinitely without the use of batteries. The human motion of a switch actuation, light on a solar cell, or temperature differentials in the environment provide power to LevNet RF Transmitters, eliminating additional expenses to the end user's energy bill and allowing zero maintenance wireless devices.

    Leviton LevNet RF Devices are ideal for use in a variety of applications:
    • Retrofits - New construction
    • Conference rooms - Classrooms
    • Lounges/Lobbies - Private offices
    • Executive offices - Restrooms
    • Daycare facilities - Multimedia areas

  • Specifications
    Manufacturer Leviton
    Manufacturer Product No. WSP05-080
    UPC 078477484371
    Range 50-150 feet
    Radio Frequency 315MHz
    Power Supply Input Rating 240VAC, 50/60Hz
    Voltage 240V
    Max Loads/Contact Ratings Tungsten/Incandescent 1,000W, Fluorescent Ballast 3A, General Duty 6A, A300 Pilot Duty 240VA
    Output Channels 1 FORM A Relay

  • 1 Review

    Review of 86585 Review by CARLOS
    Review of 86585

    I did not use this relay shown here, I went with the 500 watt 120 volt model and after getting it programmed to the cooresponding wireless self-powered Leviton/levnet RF type switch. This device is working perfectly.

    Posted on 2/16/2013

    Leave a Review

    Only registered users can write reviews. Please, log in or register

    • 1x - WSP05-80 LevNet RF 3-Wire Relay Receiver, 1,000 Watts
    • 1x - User's Instructions

Please wait...