I/O Linc - Insteon Low Voltage / Contact Closure Interface ( 1 In / 1 Out )

Insteon Remote Control Plug-in Low Voltage Controller

Expand your Insteon Network to monitor and control low voltage and contact closure devices
  • Monitor and control pool valves, electric door strikes, garage doors and more using your Insteon network
  • 4 output relay modes allow you to control many different types of devices
  • Control Insteon lights and appliances using standard sensors
  • Contains 1 sensor input and 1 output relay (NO/NC)
  • For control from an Insteon Mini Remote, you will need a Range Extender or other dual-band Insteon devices*
  • Can be used with an Insteon Hub however the included IOLinc module communicates via powerline only, so you may need a Range Extender or other dual-band Insteon devices*
  • Award-winning Insteon technology provides superior performance and reliability
* The included Insteon IO Linc module communicates over powerline only, which may cause issues if you are trying to remotely operate Insteon devices on a different electrical phase (circuit) or from a Mini Remote. We recommended adding a Range Extender on the same phase to bridge the IO Linc module with Insteon RF-only or Dual-band devices.


REWARDS: 45 points
  • Details
  • Specs
  • Reviews
  • Manuals
  • What's Included
  • The latest Insteon plug-in module, I/O Linc, lets you monitor and control any low voltage devices such as alarm sensors, electric door strikes, and contact closures as part of your Insteon home automation network. With one dry-contact sensor input you can control many Insteon devices throughout the house. Plus, use the built-in single-pole double-throw (SPDT) switch, connect any low voltage-powered device for continuous or momentary operation. Create your own remote-control door lock using an electric door strike and power supply or use a security sensor turn Insteon controlled lights on or off.

    Required Accessories

    Sensor wire: 16 - 28 gauge wire fits, but 20 - 22 gauge recommended

    I/O Linc's flexible output relay can control many different types of low voltage devices, from pool valves to electric door strikes to garage doors due to its different relay modes. When controlling devices like pool valves, you will want the ability to leave it on for an extended period of time, giving it plenty of time to fill the pool. As it approaches the desired water level, then you can remotely turn it off. For devices like electric door strikes, set I/O Linc's output relay to momentary, allowing you open the front gate using a RemoteLinc or any other Insteon controller. A third version of I/O Linc's momentary mode allows you to remotely press your garage door button with an Insteon On command, but only if your garage is currently closed. This allows you to open your garage with On command and close it with an Off command. Because I/O Linc uses a garage door sensor to know whether the door is open or closed, it only controls the garage when it needs to.

    Controlling Two Separate Loads

    With the addition of a DPDT Relay Board, the I/O Linc is capable of switching two separate loads on and off together. In this configuration, the I/O Linc could control two different loads of varying voltages (i.e. one high voltage and one low voltage load) or two higher current loads (up to 7A @30VDC each).

  • General
    Manufacturer Insteon
    Manufacturer Product No. 2450
    UPC 689076403542
    FCC ID SBP26722A
    Certifications FCC, IC Canada
    Patent No. Patent No. 7,345,998, International patents pending)
    Color White
    Warranty 2 Years, limited
    Status LED Yes
    Insteon RF mesh repeater White (Bright when relay closed, dim when relay open)
    Sensor Status LED Green (On when sensor closed, Off when sensor open)
    Set Button Toggles output relay On/Off. Also used for setup
    Momentary Duration Locally Adujtable: 2 Seconds to 30 Minutes
    Software Adjustable, .2 Seconds - 105 minutes
    Operation Modes Insteon
    Multi-Way Circuit Support Yes
    Setup Memory Non-volatile EEPROM
    Insteon Features
    Insteon Addresses 1 hard-coded out of 16,777,216 possible
    Insteon Links 417
    Insteon Powerline Frequency 131.65 KHz
    Insteon Minimum Transmit Level 3.2 Vpp into 5 Ohms
    Insteon Minimum Receive Level 10 mV
    Insteon Messages Repeated Yes
    I/O Terminals 5V (10mA)
    Common (28-16 gauge wire)
    Input jack 1/8" mini jack input (GND, Sense)
    Input Type Contact closure only
    Output Relay Capacity 5A @ 30 Volts (AC or DC)
    Operating Conditions Indoors: 32 to 104°
    up to 85% relative humidity
    Dimensions 4.5" H x 2.5" W x 1.5" D
    Weight 4.6 oz
    Supply Voltage 120 Volts AC +/- 10%, 60 Hertz, single phase
    Sensor Input 1/8" mini jack input (GND, Sense)
    Power Plug 3-pin grounded
    Retains all settings without power Yes, saved in non-volatile EEPROM
    Pass-through Outlet Uncontrolled 3-prong (with ground), 120V, 15A
    Power Consumption 0.93 Watts
    Certification Safety tested for use in USA and Canada
  • Reviews 41 - 50 of 156

    1. 1
    2. ...
    3. 3
    4. 4
    5. 5
    6. 6
    7. 7
    8. ...
    9. 16
    Review of 2450 Review by JAMES
    Review of 2450

    Using it with a magnetic proximity switch on the garage door. Works great.

    Posted on 3/28/2013

    Review of 2450 Review by JAMES E
    Review of 2450

    Using it with a magnetic proximity switch on the garage door. Works great.

    Posted on 3/28/2013

    Review of 2450 Review by JOEL
    Review of 2450

    Works great. I use it for my garage door in conjunction with a wireless camera.

    Posted on 3/9/2013

    Review of 2450 Review by
    Review of 2450

    This thing is pretty cool. I coupled it with a pressure mat and now it turns on a night light for 5 minutes if you step on the pad in the middle of the night.

    Posted on 1/10/2013

    Review of 2450 Review by RICHARD
    Review of 2450

    Works just like you said it would.

    Posted on 12/26/2012

    Review of 2450 Review by DAVID
    Review of 2450

    Easy to install. Good instructions.

    Posted on 12/22/2012

    Review of 2450 Review by JAMES
    Review of 2450

    I attached to the output of my sensaphone 400 installed in my Florida condo along with an appliance module to which my router is plugged in. I can now reboot my router when it locks up from 1000 + mile away. Great product.

    Posted on 12/13/2012

    Review of 2450 Review by CHEN
    Review of 2450

    Works great for the garage door with KeypadLinc single button using mode two. Wish if it has more than one input and one output. Cheaper if you buy separate magnetic switch for the garage door.

    Posted on 12/8/2012

    Review of 2450 Review by DENNIS
    Review of 2450

    I tied this together with the Aleph America FS-3101 Fluid Level Sensor to monitor my sump pump well. I hope that I never find out how well it works.

    Posted on 12/8/2012

    Review of 2450 Review by Paul
    Review of 2450

    I have 3 of these now: 1 for the garage operated from a keypad link, 1 in the attic on a temp alert to keep it cool, 1 on a photo cell to give me exact dusk, compensating for cloudy conditions.

    All three of these used to be x10 and worked mostly and ok... which lead to low WAF. Now its 100% and perfect. I don't worry about these things or monitor them any longer.

    One little squawk to be aware of: I used insteon as a bridge off of x10. The X10 psc01 powerflash had more flexible and forgiving inputs.. low voltage and dry contact. The inlinelinc is pretty rigid sometimes about which way the contacts are wired to devices and does not do lowvoltage like the psc01.. be ready if upgrading from x10. I would have gone 5 stars if this were the same

    Posted on 11/20/2012

    Leave a Review

    Only registered users can write reviews. Please, log in or register

    • 1x - I/O Linc
    • 1x - 1.5mm flathead screwdriver
    • 1x - Quick Start Guide

Please wait...