I/O Linc - Insteon Low Voltage / Contact Closure Interface ( 1 In / 1 Out )

Insteon Remote Control Plug-in Low Voltage Controller

Expand your Insteon Network to monitor and control low voltage and contact closure devices
  • Monitor and control pool valves, electric door strikes, garage doors and more using your Insteon network
  • 4 output relay modes allow you to control many different types of devices
  • Control Insteon lights and appliances using standard sensors
  • Contains 1 sensor input and 1 output relay (NO/NC)
  • For control from an Insteon Mini Remote, you will need a Range Extender or other dual-band Insteon devices*
  • Can be used with an Insteon Hub however the included IOLinc module communicates via powerline only, so you may need a Range Extender or other dual-band Insteon devices*
  • Award-winning Insteon technology provides superior performance and reliability
* The included Insteon IO Linc module communicates over powerline only, which may cause issues if you are trying to remotely operate Insteon devices on a different electrical phase (circuit) or from a Mini Remote. We recommended adding a Range Extender on the same phase to bridge the IO Linc module with Insteon RF-only or Dual-band devices.


REWARDS: 45 points
  • Details
  • Specs
  • Reviews
  • Manuals
  • What's Included
  • The latest Insteon plug-in module, I/O Linc, lets you monitor and control any low voltage devices such as alarm sensors, electric door strikes, and contact closures as part of your Insteon home automation network. With one dry-contact sensor input you can control many Insteon devices throughout the house. Plus, use the built-in single-pole double-throw (SPDT) switch, connect any low voltage-powered device for continuous or momentary operation. Create your own remote-control door lock using an electric door strike and power supply or use a security sensor turn Insteon controlled lights on or off.

    Required Accessories

    Sensor wire: 16 - 28 gauge wire fits, but 20 - 22 gauge recommended

    I/O Linc's flexible output relay can control many different types of low voltage devices, from pool valves to electric door strikes to garage doors due to its different relay modes. When controlling devices like pool valves, you will want the ability to leave it on for an extended period of time, giving it plenty of time to fill the pool. As it approaches the desired water level, then you can remotely turn it off. For devices like electric door strikes, set I/O Linc's output relay to momentary, allowing you open the front gate using a RemoteLinc or any other Insteon controller. A third version of I/O Linc's momentary mode allows you to remotely press your garage door button with an Insteon On command, but only if your garage is currently closed. This allows you to open your garage with On command and close it with an Off command. Because I/O Linc uses a garage door sensor to know whether the door is open or closed, it only controls the garage when it needs to.

    Controlling Two Separate Loads

    With the addition of a DPDT Relay Board, the I/O Linc is capable of switching two separate loads on and off together. In this configuration, the I/O Linc could control two different loads of varying voltages (i.e. one high voltage and one low voltage load) or two higher current loads (up to 7A @30VDC each).

  • General
    Manufacturer Insteon
    Manufacturer Product No. 2450
    UPC 689076403542
    FCC ID SBP26722A
    Certifications FCC, IC Canada
    Patent No. Patent No. 7,345,998, International patents pending)
    Color White
    Warranty 2 Years, limited
    Status LED Yes
    Insteon RF mesh repeater White (Bright when relay closed, dim when relay open)
    Sensor Status LED Green (On when sensor closed, Off when sensor open)
    Set Button Toggles output relay On/Off. Also used for setup
    Momentary Duration Locally Adujtable: 2 Seconds to 30 Minutes
    Software Adjustable, .2 Seconds - 105 minutes
    Operation Modes Insteon
    Multi-Way Circuit Support Yes
    Setup Memory Non-volatile EEPROM
    Insteon Features
    Insteon Addresses 1 hard-coded out of 16,777,216 possible
    Insteon Links 417
    Insteon Powerline Frequency 131.65 KHz
    Insteon Minimum Transmit Level 3.2 Vpp into 5 Ohms
    Insteon Minimum Receive Level 10 mV
    Insteon Messages Repeated Yes
    I/O Terminals 5V (10mA)
    Common (28-16 gauge wire)
    Input jack 1/8" mini jack input (GND, Sense)
    Input Type Contact closure only
    Output Relay Capacity 5A @ 30 Volts (AC or DC)
    Operating Conditions Indoors: 32 to 104°
    up to 85% relative humidity
    Dimensions 4.5" H x 2.5" W x 1.5" D
    Weight 4.6 oz
    Supply Voltage 120 Volts AC +/- 10%, 60 Hertz, single phase
    Sensor Input 1/8" mini jack input (GND, Sense)
    Power Plug 3-pin grounded
    Retains all settings without power Yes, saved in non-volatile EEPROM
    Pass-through Outlet Uncontrolled 3-prong (with ground), 120V, 15A
    Power Consumption 0.93 Watts
    Certification Safety tested for use in USA and Canada
  • Reviews 91 - 100 of 156

    1. 1
    2. ...
    3. 8
    4. 9
    5. 10
    6. 11
    7. 12
    8. ...
    9. 16
    Review of 2450 Review by Snowmelt
    Review of 2450

    I use it to turn on snow melt on my driveway. It continually randomly turns on the driveway which costs me a bunch of money to have running when it's not snowing. I can not figure out the sensor. The manual is useless. Terrible product. I don't know why it can't work like the other dimmers and switches.

    Posted on 1/4/2012

    Review of 2450 Review by MICHAEL
    Review of 2450

    Great flexible product. Realize that the outlet is always on.

    Posted on 1/2/2012

    Review of 2450 Review by PAUL
    Review of 2450

    So far so good (owned it for about one month). Does what it was supposed to without a hitch. I like the fact that is highly configurable. For example, you can trigger the built-in relay when the sensor triggers as well as control other Insteon devices.

    Posted on 12/29/2011

    Review of 2450 Review by JOHN
    Review of 2450

    I am sure it will work fine once the RFUGR works

    Posted on 12/28/2011

    Review of 2450 Review by STEVEN
    Review of 2450

    Wish it had more input and outputs.

    Posted on 12/28/2011

    Review of 2450 Review by STEVEN D
    Review of 2450

    Wish it had more input and outputs.

    Posted on 12/28/2011

    Review of 2450 Review by JOHN
    Review of 2450

    I am using this to detect and control my garage door, and it simply works. Plugged it in next to the opener, connected short wires to control it, then ran wires from the magnetic door sensor. I control it with an ISY99, and set a program that will automatically close the door at night in case we forget. Total time < 1 hr.

    Posted on 11/30/2011

    Review of 2450 Review by ERNIE
    Review of 2450

    Cool unit. Hooked it up to a cheap thermostat then linked to an appliance module to control a heater in that remote room. Works like a charm.

    Posted on 11/24/2011

    Review of 2450 Review by DAVID
    Review of 2450

    Worked as adverstised. These modules are better than the old X-10 for a large house like I have. X-10 just didn't get the job done, but now these modules and the Toggle LInk Relays get excellent, troublefree coverage.

    Posted on 11/24/2011

    Review of 2450 Review by Merchon
    Review of 2450

    Works, but every device I own has failed!

    Posted on 11/22/2011

    Leave a Review

    Only registered users can write reviews. Please, log in or register

    • 1x - I/O Linc
    • 1x - 1.5mm flathead screwdriver
    • 1x - Quick Start Guide

Please wait...