GE Security TX-1510-01-1 DesignLine Recessed Door/Window Sensor

GE Security TX-1510-01-1 DesignLine Recessed Door/Window Sensor

Discreet Sensor Hides Inconspicuously in Door Frame
  • Replaceable lithium battery lasts up to 5 years
  • Standard flush-mount and flanged tops included
  • Supervisory reports of battery and transmitter condition
  • Easy installation requring only 1 drill bit
  • Compatible with ELK systems



List Price: $80.00

Your Savings: $26.81

REWARDS: 53 points
  • Details
  • Specs
  • Reviews
  • The GE Security TX-1510-01-1 DesignLine Recessed Door Contact is the industry's finest supervised, recessed door contact. Hidden within the door frame, the DesignLine contact is ideal for use when a discreet sensor is required for use in a window or door security application. The contact uses a replaceable lithium battery that lasts up to five years under normal usage and comes with a standard flush-mount and a flanged top. The DesignLine Recessed Sensor is ideally used with wood doors/windows and is compatible for integration with Elk security systems.

  • Battery: CR2032, 3 VDC, 225 mAh, Lithium Coin Cell
    Typical Battery Life: 5 years
    Transmitter Frequency: 319.508 MHz (crystal-controlled)
    Transmitter Frequency Tolerance: +/- 8 kHz
    Bandwidth: 24 kHz
    Modulation Type: Amplitude Shift Key (ASK)
    Unique ID Codes: 16 million
    Peak Field Strength: Typical 30,000 u V/m @ 3m
    Magnetic Sensitivity of Reed Switch: 10 to 20 amp turns
    Reed Sensitivity: .38-in. (.97-cm) gap
    Magnet Type: Nd-Fe-B, N45
    Magnet Dimensions (WxHxD): 0.7 in. (1.8 cm) long x 0.75 in. x (1.9 cm) diam.
    Supervisory Interval: 64 minutes
    Operating Temperature: 10 degrees F (-12 degrees C) to 120 degrees F (49 degrees C)
    Enclosure: PC-540
    Weight: 0.45 oz. (12.6g)
    Dimensions: 1.55 in. (3.92cm) long x 0.87 in. (2.21 cm) diam.
    Color: Belgian Grey
    FCC Standard: FCC Part 15
  • 1 Review

    Review of 79463 Review by John
    Review of 79463

    Range is good and they set up very easily. The neodymium magnet is very strong so the reach is good as well, you don't need near contact to make them work. These are really designed for wood doors and windows. If you try anything else beware notes below.

    I had a few issues:

    Installation instructions say drill 7/8 hole. That is wrong! The unit is slightly over 13/64 so 7/8 is too large. Drill a 3/4 and file a little to make it fit.

    If you have retrofit windows installation will be difficult and maybe impossible. You need a pretty deep hole to install the transmitter. The old aluminum frame is in the way an you inevitably hit the edge of some part of the old frame so you can't just drill it out. Also, on the window side the depth may not be sufficient to hold the magnet shallower of the two parts. This too is a problem. Taken together installation with retrofit windows is VERY difficult.

    Posted on 7/5/2012

    Leave a Review

    Only registered users can write reviews. Please, log in or register

Please wait...