ELK Products ELK-M1PCSPIM UPB Interface for M1G & M1EZ8

Create a Permanent Connection Between your Elk M1 Gold and UPB Network to Combine Security with Automation
  • All-in-one M1 to UPB Interface
  • Compact size
  • Requires 4-wire data bus connection
  • Includes status lights for M1 data bus and UPB
  • Low cost solution
  • Removable 4-pin Connector


  • Details
  • Specs
  • Reviews
  • The ELK-M1PCSPIM Power Line Interface Module is special in that the M1XSP Serial Port chip is housed inside of the unit. Now you can easily connect an ELK M1 controller to a UPB network with this all-in-one device. This unit will need to be plugged into an AC power outlet to allow UPB communication. The ELK M1 data bus hub is required to make a 4-wire connection to the interface, and allow enrollment of the device. UPB is a Power Line Carrier (PLC) lighting and automation technology. The UPB signal will take advantage of your existing wiring to allow remote control over your home lighting and appliances without the need for new construction. Adding this item to your existing ELK security system is an easy and affordable way to begin combining your home security with home automation.

  • Specifications
    Manufacturer ELK Products
    Manufacturer Product No. ELK-M1PCSPIM
    UPC 762158550737
    Temperature -40°C to +70° C
    UPB Network circuitry voltage Powered from the AC "Primary" Line
    M1 Data Bus Device circuitry voltage Powered (12VDC) from the M1 Data Bus (+) & (-) terminals
    Current Draw from M1 ~30mA @ 12 VDC
    M1 Bus Device Address Preset at Address #7 [Requires bus module enrollment]
    Firmware required 1.0.42 (std. firmware) or later

  • Leave a Review

    Only registered users can write reviews. Please, log in or register

Please wait...