Elk Electric Water Shutoff Valve

Remotely Shutoff Main Water Supply to Stop Water Damage from Leaks or Burst Pipes
  • Remote shutoff of main water supply
  • Rapid opening and closing
  • Manual override handle
  • Integrates with security or automation controllers
  • Can be connected to wireless receivers or pushbuttons
  • Compatible with INSTEON Water Leak Sensors


  • Details
  • Specs
  • Reviews
  • Manuals
  • What's Included
  • Don't let your home or office fall victim to a pipe burst. By connecting Elk's Electric Water Shutoff Valve to your home automation controller or security system, your water main can be quickly shutoff (approximately two seconds) before significant damage is done. A water sensor (sold separately) can be placed anywhere that might be a potential source for a leak, such as under your washing machine, by the water heater, or on the bathroom floor. When a leak is detected it sends out a signal to your home automation controller or security system which will trigger the Elk Electric Water Shutoff Valve to turn the water main off, usually in less than two seconds.

    Built for Years of Service
    Elk's Electric Water Shutoff Valve is a full-port, two-way ball valve with a one inch bore, it is made of 316 stainless steel and is safe for drinking water. The motorized actuator has a permanently lubricated gear drive with sufficient torque to open or close the valve under high pressure or after long periods of inactivity. This valve is built with commercial-grade seats and seals for a long service life. It is a non-restricting valve, which meets the approvals of state and municipal water authorities.

    Versatile Electrical Connections
    The Electric Water Shutoff Valve can be operated via a simple 12-volt DC input from a security or automation controller such as the M1 Gold System, INSTEON-Enabled M1 Gold System, or M1EZ8. You'll need a water sensor to tell your automation system there's water on the floor, such as the INSTEON Water Leak Sensor. Operating time from fully open to fully close is approximately two seconds.

    Use with INSTEON Water Leak Sensors
    Combine INSTEON Water Leak Sensors, an I/O Linc, Hub and 12V power supply to create a simple wireless water leak alert system. Once setup, users can receive a push notification or email message when leaks are detected and will activate the Elk Electric Water Shutoff Valve to prevent further damage to your property.

  • Specifications
    Manufacturer Elk Products, Inc
    Manufacturer Product No. ELK-WSV2
    UPC 762158550843
    Dimensions D 4 inches x W 4.5 inches x H 7.75 inches
    Valve Full port, 2-way ball valve
    Construction Stainless Steel Grade 316
    Pipe Connections 1 inch NPT threaded pipe connection
    Approval NSF61 approved for drinking water
    Power Supply 12V DC
    Nominal Current Draw 800mA to 1.5 Amp
    Actuating Speed < 2 seconds
    Enclosure NEMA 6P and 7D enclosure
    Connections 18 gauge, 4 conductor cord
    Indoor Use Yes
    Outdoor Use Yes
    Manual Override Handle Yes
    Manufacturer Warranty Two (2) years
  • Leave a Review

    Only registered users can write reviews. Please, log in or register

    • 1x - Electric Water Shutoff Valve
    • 1x - Instructions

Please wait...