- What's Included
Works on Any Standard VoltageThis Relay Contactor Module can be easily configured to operate on 110/120, 208, 240, or 277 volts AC. There are two separate normally open relays in this module, which can be configured to operate two loads independently. The voltage that operates the logic circuits can be used to power the loads, or the loads can use completely separate power.
NOTE: The contactor module must be removed from the enclosure to set the jumpers. Spread the enclosure sides apart a little to release the catches that hold the module in place. Refer to the photo below to see where the jumpers are located.
Outdoor EnclosureThe Z-Wave 30A Relay Contactor Module comes in a rainproof, lockable enclosure, so you can mount it close to your appliance.
Automate Your Entire Home with Z-Wave TechnologyAny device displaying the Z-Wave logo can be incorporated in your Z-Wave network. Since Z-Wave operates on RF frequencies and every device is a repeater, the more devices you use, the better your network functions. There is a wide variety of Z-Wave devices made by several manufacturers, and any of these can add more automatic functions to your network.
Full Line of InTouch Z-Wave Devices Available
- USB Stick and HomeSettings Software
- 600w Dimmable Wall Switch
- 15A Relay Wall Switch
- 15A Receptacle
- 1-Scene Remote Wall Controller
- Hand-Held Remote Controller
- Indoor PIR Motion Sensor
Manufacturer: Intermatic Manufacturer Product No.: CA3750 UPC: 078275096189 Dimensions: 9
- Review of 119303 Review by guest
Review of 119303
All Z-wave devices works like this for first time pairing. The device it self is great
Posted on 1/26/2014
- Review of 119303 Review by THOMAS
Review of 119303
The only way to program this is with the remote and base within 5 feet of the controller.
Posted on 4/12/2008
Leave a Review
- Z-Wave 30A Relay Contactor Module
Copyright 1995-2015 SMARTHOME®
Item has been removed from your cart