- What's Included
The Twister from Solar Sun Rings is a new and revolutionary accessory that allows for your pool cleaner to take a random and thorough cleaning pattern throughout your swimming pool floor. It's power steering for your pool cleaner. TWISTER is an Above Ground Pool Cleaner accessory made of corrosion and impact resistant materials. It is designed to operate only with suction side cleaners and has a gear box with a set of gears, sprockets, and shafts which is powered by the water suction from your pool pump. This suction enables the front face of TWISTER to rotate and counter rotate about 3 times an hour.
What are the Twister End Caps for? Every Twister comes with two blue end caps that are two inches in diameter. These end caps are to be applied onto the cut ends of your pool hose and are designed to protect those sections and to provide a finished look on y our Twister hose assembly.
What is the 30° Angled Adapter for? The Twister is designed to fit between your cleaner and the section of pool hose which would connect to the cleaner. The angled adapter, once installed on a hose line with a Twister also installed and in operation, is intended to alter the thrust angle of your pool cleaner. In other words, the angled adapter dramatically changes the direction which the cleaner is pointing.
Why does the Pool Hose need to be cut at 2 feet? TWISTER needs to be completely submerged underwater for it to function properly. Years of research and development has shown that a length of hose longer than two feet between the skimmer and TWISTER would leave too much slack and run the risk of allowing TWISTER to lift over water level to draw in air. A length of hose shorter than 2 feet would be too stubby and would allow TWISTER to rise above water level, drawing in air. The 2 foot of hose rule is applied for this reason to ensure the best performance possible for TWISTER and your cleaner.
Will Debris Flow Through the Twister and Clog it? TWISTER has gone through years of development prior to release in North America, one of the considerations during development was regarding positioning of the leaf catcher. It was determined that if the leaf catcher was installed between TWISTER and the cleaner, then the leaf catcher may turn over and lose the contents and also be too much of a weight burden for TWISTER, affecting it's performance. Because of this, TWISTER was designed to take in whatever piece of debris the cleaner can take.
Specifications Manufacturer Solar Sun Rings Inc. Manufacturer Product No A1895 UPC 894267002057 Cleaner Compatibility All suction side cleaners Manufacturer Warranty One Year Limited Warranty
- Review of 37885 Review by CHASE
Review of 37885
My pool cleaner never gets stuck and covers all areas of the pool now!
Posted on 7/10/2014
Leave a Review
- 1x - Twister Unit
- 1x - 30° Angled Adapter
- 2x - Hose End Caps
- 1x - Installation Instructions
- 1x - Twister Unit