OPEN BOX ITEMThis is a fully functional returned or demo product. May not have original packaging and may have cosmetic imperfections. Exchanges accepted for defective products only.
- What's Included
The Plasma-Friendly J-Box IR Receiver mounts easily into a single-gang electrical J-Box. The Decora-style box will match a Decora-style plate, should you want to use one. This provides an integrated look for control of A/V equipment behind closed doors or any IR repeater system that is in close proximity to a plasma display.
This IR receiver is a four-screw terminal block that interfaces with Xantech connecting blocks such as the One-Zone Connector Block with One Emitter Out, the One-Zone Connector Block with Four Emitters Out or the 10-Emitter Connecting Block. The connecting blocks then deliver your IR signals to your components.
The Plasma-Friendly J-Box Receiver works in normal 3-wire mode and will work properly near fluorescent lights or direct sunlight. An RF grid is included for EMI reduction. Additional features include a talkback LED for IR reception and full system operation indication.
If you don't have a plasma screen, try the standard J-Box IR Receiver.
Manufacturer: Xantech Manufacturer Product No.: 780-95 UPC: 042777313075 Dimensions: 4 1/8" H x 1 5/8" W x 1 3/8" D IR Modulation Frequency Bandwidth: 30 - 100kHz Reception Range: Up to 50 feet (18m) depending on local conditions Reception Angle: 45 degrees off axis at 50% range reduction Cable Requirements: 3-conductor Cable Gauge Requirements: 24-gauge up to 200 feet (61m); 22-gauge up to 600 feet (180m); 20-gauge up to 2000 feet (600m); 18-gauge up to 5000 feet (1.5km); unshielded okay Maximum Transmission Length: One mile (1.6km) using 18-gauge wire Maximum Current Output: 100 mA (pulse) Power Requirements: 12 volts DC @ 20mA Outputs: IR out, GND, Status, +12V Resists interference from: Plasma, LCD, CFL, sunlight
- Mounting screws
- IR receiver
- Mounting screws