Designed to work with the Leviton OSPxx power pack, this occupancy sensor saves you energy and money by making sure lights don't stay on if no one is in the room. It uses three color-coded, low-voltage wires and a single mounting post for hassle-free installation. A light sensing photo cell also ensures the lights don't come on when there is ample sunlight to avoid wasting electricity. A Fresnel lens creates divides the detection area into dozens of different segments for optimum sensitivity. Using passive infrared (PIR) technology, the sensor will turn the wired lights on if motion is detected. The lights will stay on as long as the sensor thinks the room is occupied. If movement is no longer sensed, the lights will automatically turn off. You'll save money by ensuring lights aren't left on longer than they need to be. Or stop fumbling for a light or lamp switch in rooms that may not have a switch conveniently located near the entrance.
Specifications General Manufacturer Leviton Manufacturer Product No. OSC04-I0W UPC 078477180532 Lens Type High Density Coverage 450 square feet Controls PIR (Infrared Sensitivity) High to low Timer Adjustment (Manual) 30s to 30 min. Factory set 10 min. PC (Photocell Adjustment) 20 to 3,000 Lux - Factory set 3,000 Lux (Disable photocell) Other Construction Housing - Rugged, high-impact, injection molded plastic. Color coded leads are 6" long (16.24 cm). Dimensions 4.5" diameter, 1/5" high (114 mm diameter, 38 mm high Weight 5 oz (142 g) Power Requirements 24 VDC, 20mA from the OSPxx-series power pack Output 24 VDC active high logic control signal with short circuit protection Operating Environment 32 to 104 degrees F (0 to 40 degrees C), 0 to 95% relative humidity, non-condensing. For indoor use only. Warranty Five-year limited
Leave a Review