iON Security Products iON Plunger-D Wireless Door Sensor for DSC Wireless Security Systems
Share Share Share Share Share
Rewards: 52 Points

iON Security Products iON Plunger-D Wireless Door Sensor for DSC Wireless Security Systems

Fully Concealed, Easy to Install and Configure Wireless Sensor
  • Fully concealed wireless sensor
  • Compatible with current DSC Wireless receivers
  • Only a drill, a 3/4 inch Forstner bit, and a 1/4 inch wood bit (for antenna insertion) are required for installation
  • Micro-processor, Micro-transmitter, Lithium Battery, Optimized Antenna for superior zone signal
  • Long-life Battery - 5+ years (average rating)

Item #: 73171

In Stock! SHIPS TODAY!

Special Price: $26.57

List Price: $32.99

Your Savings: $6.42

Frequently Bought Together:

Price For Both: $53.14

  • Details
  • Specs
  • Reviews
  • A bulky home security system can be an eyesore. Adding to that stress is hard wire installation permanently altering the aesthetics of a room, door or window treatment. With its wireless connectivity and fully concealed platform, however, the iON Security Plunger is a door security sensor that finally eliminates these pesky inconveniences. A captive magnet within the Plunger activates a reed switch when the plunger is depressed.

    Also available for GE wireless receivers. Please see the 3/4" Forstener bit, recommended for installation.

    Smarthome does not accept defective returns for this product. You will need to contact the Manufacturer (or Supplier) directly for all warranty issues.


    Installation
    Installing the product requires just three tools:

    1. Drill
    2. 3/4" Forstener bit
    3. 1/4" wood fit (for antenna insertion)

    Meant to fit snugly on the hinge-side door jamb and to be concealed by the closed door, you simply drill a 1" deep hole using the 3/4" Forstner bit, followed by a 1/4" hole drilled into the center of the cavity where the antenna must be inserted. Once you feed the antenna into the 1/4" hole, you merely press and secure the iON Security Plunger into the open cavity, and your instillation is complete!

    From then on your fear of any burglars spotting your motion sensors and finding alternate and less-secure entryways into your home or commercial space can be forgotten, because this 3 step easy-to-install package is not only virtually invisible to the naked eye, but it uses a sophisticated wireless transmit that extends to 500 ft of the wireless receiver - making it an ideal choice for installing in just about any corner of your home or office.

    The iON Security Plunger's battery-life is another one of its convenient features, as its 3.0V Lithium Coin Cell Battery has an average life-span of about 5+ years, ensuring you and your family's safety will not be compromised by the vexing and easily forgettable task of constantly having to replace your battery.

    • Dimensions: 0.33 in. deep x 0.75 in. diameter
    • Fully concealed in wood door frame
    • Compatible with all DSC Wireless receivers
    • 500 ft open air wireless transmit range
    • Long-life Battery - 5+ years (avg)
  • 6 Reviews

    Review of 73171 Review by JOE
    Review of 73171
    Rating

    I installed this on five doors and they all worked great! Two of the doors were exterior French doors and this was very easy to install. The wireless DSC setting was a simple enrollment and detected all doors including the one in the basement.

    Posted on 7/22/2014

    Review of 73171 Review by THEODORE
    Review of 73171
    Rating

    Easy to install, works great. Better than the window counterpart because it adds less thickness between the door and the frame.

    Posted on 6/23/2013

    Review of 73171 Review by Blue
    Review of 73171
    Rating

    Works great until you have to remove them to replace a battery. I got over 6 years on the original batteries. Over time, my wood door jambs swelled around the units, freezing them in place. I had to destroy them just so I could remove them. Now that they are removed, I don't need to replace the costly batteries. Oh jolly. Now I'm looking for surface mount units that take AAA batteries.

    Posted on 2/22/2013

    Review of 73171 Review by Blue Hawaii
    Review of 73171
    Rating

    Works great until you have to remove them to replace a battery. I got over 6 years on the original batteries. Over time, my wood door jambs swelled around the units, freezing them in place. I had to destroy them just so I could remove them. Now that they are removed, I don't need to replace the costly batteries. Oh jolly. Now I'm looking for surface mount units that take AAA batteries.

    Posted on 2/22/2013

    Review of 73171 Review by JASON
    Review of 73171
    Rating

    Easy to install and works perfectly. Can't complain about anything.

    Posted on 2/2/2013

    Review of 73171 Review by DAVE
    Review of 73171
    Rating

    Easy to install, paired right up to my DCS system. Be aware that they assume you will have a wall cavity on the hinge side of your door. Both of my exterior doors had many studs in a row and a regular drill bit would not reach deep enough to make a channel for the antenna wire. If this is your situatiion, you'll need to use a nonstandard long reach bit.

    Posted on 10/7/2012

    Leave a Review

    You're reviewing: iON Security Products iON Plunger-D Wireless Door Sensor for DSC Wireless Security Systems

    • 1 star
      2 stars
      3 stars
      4 stars
      5 stars

    * Required Fields

place your order by 3pm PT for same day shipping

Please wait...

smarthome

Item has been added to your cart
smarthome

Item has been removed from your cart