| Author |
 Topic  |
|
|
Robert Walton
Starting Member
USA
1 Posts |
 Posted - 02/08/2012 : 12:51:45 PM
|
Hello,
I just installed the 59502 ir repeater, and it isn't controlling anything. The green light comes on when I send an ir signal from my Harmony 600, but nothing is turing on/off etc. Five devices are connected (HDTV, Bluray, AV reciever, Fios0 No troubleshooting or anything else exists in the instructions or web site. Any ideas, or do I need to return this item?
Thanks |
|
|
hadiesper
Starting Member
United Arab Emirates
5 Posts |
Posted - 02/17/2012 : 03:33:31 AM
|
Assuming your harmony remote learnt all the codes correctly and can control your devices directly, then I would say the repeater has something wrong.
At least you can make sure an IR signal comes out by holding the camera of your phone (iphone for example) right on the IR transmitter, you should see it flashing in purple. Normally your eyes do not see this, but if you use a camera, the frequencies become visible. Its a cool way of verifying those invisible infrared signals. |
HadiEsper
http://www.ShifraSmartHomes.com - My Smart Home |
 |
|
|
RichCini
Starting Member
USA
2 Posts |
Posted - 03/10/2012 : 10:45:58 AM
|
Interestingly, I just installed this system today in a cabinet in my den and I was having the same problem. Looking with a regular digital camera confirmed that the emitters were working. It wasn't until I closed the doors on the cabinet did the repeater work properly. There was only natural light at the time but it must have been interfering in some way.
It works fine now so I might look into the darkness aspect in your installation.
|
Rich
|
|
|
| |
Topic |
|
IR Distribution System 59502
