|
CalifDan
Junior Member
USA
31 Posts |
 Posted - 05/19/2012 : 11:16:25 AM
|
I am having trouble with the Expander. With power on it is flashing. I have 12 volts across the power. It is plugged into a M1DBH at J2. I can assign zone names and information with the software. However, where zones 1-16 will show status, the 17 - 24 zones (all I used) all show NA and no voltage.
Is this a problem with the Board? Or?
I did notice that Zone 17 in the software does not appear to update when sent to the system. Stays yellow in a few fields. |
CalifDan |
Edited by - CalifDan on 05/19/2012 11:16:54 AM |
|
M1XIN Expander
