| T O P I C R E V I E W |
| kvander51 |
Posted - 07/24/2012 : 04:29:02 AM
One of my SwitchLincs will turn on using the SmartLinc, but not off. This could be due to noise generated by the light it is controlling. To determine this for sure, can I disconnect the load and see if it will turn off or must I have some small load (e.g. 60 watt bulb} attached?
If it works that way, then we know it's noise, right? So that means I need a filter. I am not sure if the Leviton 6287 will fit inside the light fixture or in the electrical box where the switch is. Will the FilterLinc solve the problem or must the filter be located between the SwitchLinc and the offending light? |
| 5 L A T E S T R E P L I E S (Newest First) |
| kvander51 |
Posted - 07/24/2012 : 2:07:26 PM
Okay, makes sense. Thanks, I appreciate the help! |
| stusviews |
Posted - 07/24/2012 : 1:42:29 PM
A filter must be installed between the powerline and offending device. If the problem device is switched, then the filter is wired between the load wire and the device. The Leviton 6287 is intended to fit in the ceiling box. |
| BLH |
Posted - 07/24/2012 : 06:21:15 AM
If the transformer is rated to be run on a dimmer. It may work.
If you look at the SwitchLinc Dimmers Manual it cautions against doing it and indicates, do so at your own risk.
|
| kvander51 |
Posted - 07/24/2012 : 05:25:00 AM
It is actually at my neighbor's; I am helping him out with his system. Have not yet taken the fixture down, but I think it's low-voltage. If so, there's a transformer involved. That would make noise, right?
I guess that brings up another question - is it okay to use a SwitchLinc dimmer on something with a transformer? |
| EVIL Teken |
Posted - 07/24/2012 : 04:45:15 AM
quote:
Originally posted by kvander51
One of my SwitchLincs will turn on using the SmartLinc, but not off. This could be due to noise generated by the light it is controlling. To determine this for sure, can I disconnect the load and see if it will turn off or must I have some small load (e.g. 60 watt bulb} attached?
If it works that way, then we know it's noise, right? So that means I need a filter. I am not sure if the Leviton 6287 will fit inside the light fixture or in the electrical box where the switch is. Will the FilterLinc solve the problem or must the filter be located between the SwitchLinc and the offending light?
For sure that is one method to test to confirm if its the load that is affecting the *Off* state. One thing to keep in mind with respect to the filterlinc is that is is meant for a plug in device.
Whereas the Leviton filter is intended for a permanent install to isolate and filter a known noise maker. It goes with out saying you can't fit a filterlinc in a J box at all.
What is the load in question? CFL, LED, Magnetic Ballast?
Teken . . . |
