- What's Included
Fibaro Switch 2 is designed to be installed in standard wall switch boxes or anywhere else where it is necessary to control electric devices. Fibaro Switch 2 allows you to control connected devices either via the Z-Wave+ network or via a switch connected directly to it. The switch equipped with active power and energy consumption metering functionality.
Fibaro Switch 2 comes in two versions:
- Single Switch 2 (FGS-213) – Can control one electric device
- Double Switch 2 (FGS-223) – Can control two electic devices
Double Switch 2 is equipped with sockets that have an increased cross-section which allows you to connect it to wires with a larger diameter and simplify the installation process.
User-friendly Configuration Menu
A built-in RGB diode is of invaluable assistance during the installation process. The light will show whether Double Switch 2 has been added or removed from the network. You can also see whether a calibration or an update was successful.
Notification about Unused Devices
Double Switch 2 allows you to monitor electrical devices that are currently inactive. The system will notify you if you leave a device running and allow you to turn it off remotely.
Automated Water Flow Cut-off
A Flood Sensor in conjunction with an electrovalve and the Double Switch 2 module will protect your home against flooding, boasting the highest level of efficacy possible.
The new Double Switch 2 allows you to measure the power and energy of the connected load. You can see how much energy is used in your home through clear charts and use that information to reduce your electricity bills.
The Fibaro Family
Specifications Manufacturer Fibaro Manufacturer Product No. USA FGS-223 ZW5 US UPC 857934005263 Dimensions 2.56" x 2.56" x 1.78" [LxWxH] Weight .13oz Power supply 100-240V~ 50/60 Hz Rated load current UL standards (incandescent load): 5A
IEC standards: 6.5A per channel, 10A overall
UL standards (resistive loads): 6A per channel, 9.5A overall
UL standards (incandescent loads): 3A per channel
Operating temperature 0-35°C For installation in boxes Ø ≥ 50mm, depth ≥ 60mm Overcurrent protection Required external 10A circuit breaker Radio protocol Z-Wave (500 series chip) Operating Temperatuere -5 ºF to 120 ºF
Certified for outdoor use
Radio signal power Up to 1mW Radio frequency 908.4, 908.42 or 916.0 MHz US
868.4 or 869.8 MHz EU
921.4 or 919.8 MHz ANZ
869.0 MHz RU
Range Up to 50m outdoors
up to 40m indoors
(depending on terrain and building structure)
Comply with EU directives EMC 2014/30/EU
- 1x - Double Switch 2 (FGS-223)
- 1x - Fibaro Operating Manual