- What's Included
You don't need to invest in expensive cabling in order to get high-definition signals from a component to a television in another room. The Component Video & Audio Cat. 5 Driver Kit allows you to run stereo audio and high-definition video signals up to 500 feet over affordable cat. 5 wiring. Simply mount the transmitter plate by your gear and the receiver plates by the television. The receiver plates will require wall plates (sold separately).
Thanks to the latest in low noise amplification, signals stay crystal clear with virtually no signal degradation. Determine the best routing of cat. 5 wire between your source equipment and the television monitor and run the appropriate number of cat. 5 wires for your application; note that some cat. 5 driver plates require two runs of wire. Connections are made by stripping about 1/4 inch of insulation off the individual wires in the cat. 5 wire, inserting the wire end into the proper locations on the screw connector and tightening screws.
Cat. 5 Driver Kits are also available for composite video & audio, component video & digital audio, and component video only.
Manufacturer: Audioplex Technology Manufacturer Product No.: C5CVAK Dimensions: Transmitting unit: 4 1/2" x 4 9/16" x 2 1/4"; receiving units: 4 1/8" H x 1 7/16" W x 2 1/2" (audio) / 2 3/8" (video) D Front Connector: Gold-plated RCA connectors Rear Connector: Screw-down connectors Bandwidth: -3 dB BW 30 MHz at 200 feet Power: 9V AC Warranty: Lifetime, limited
Leave a Review
- Audio receiver
- Video receiver
- Audio/video transmitter in wall plate
- Mounting hardware
- Power supply
- Audio receiver