ACT RD134W Wall Mount A10 Dimmer - White
Share Share Share Share Share
Rewards: 37 Points

ACT RD134W Wall Mount A10 Dimmer - White

Be the first to review this product

Dim a Set of Lights with an A10 Command

Item #: 22016WH

Product is unavailable

Special Price: $37.50

List Price: $52.50

Your Savings: $15.00

  • Details
  • Specs
  • Reviews
  • What's Included

  • These switches work with the commonly-used X10/PLC signals, as well as the proprietary A10 protocol. This makes them ideal for remote or timed control with any X10 transmitter, intelligent controller or X10-based home automation software. Switches respond to "All Lights On," "All Units On," "All Lights Off" and "All Units Off." They're even capable of two-way powerline communication, including the ability to report status upon a status request from an intelligent controller.

    Capable of a Virtual 3-Way Switch
    Because these switches can be controlled from another location from another switch with the same address, they're ideal for creating a virtual 3-way switch. It's ideal for anyone that wants to control a set of lights from more than one location, without having to hire an electrician to run an additional wire between the two switches. Each switch's address can be set via easy, push-button configuring.

    Status LED
    A status LED verifies power to the unit and indicates status and power. The LED can be set to be "ON" (direct acting) or "OFF" (reverse acting) when load is off.

    Note: Because these switches respond to ALL LIGHTS ON, use care when controlling non-lamp loads. Use an X10 appliance module or wall receptacle if you don't want your device to respond to that command.

    • Electrical Requirements
      • Power
        • Supply Voltage: 120 VAC, +/-10%
        • Frequency: 50 or 60 Hz
      • Signal
        • Signal Input: 120 KHz, X10 Powerline Carrier, sensitive to 25 millivolts peak to peak
        • Signal Output: (Status) 120 KHz, X10 Powerline Carrier, minimum 6V peak to peak @ 5 ohm
      • Controlled Output
        • Internal triac: Enclosed, flying lead connections
        • Maximum switching power: 300 watts, 200 watts with break-off side tabs removed
        • Fuses: One (1) .5 amp slo blow on control circuit, factory replaceable only
        • Disconnect: Load Disconnect or Air Gap Switch on face disconnects load for service
    • Mechanical Requirements
      • Dimensions: 2.7" L x 1.75" W x 1.6" H
      • Weight: Less than 16 ounces
      • Mounting: Mounting plate for standard electrical switch box
      • Connections: Flying Leads: BLACK (Line) -16 AWG, BLUE (Load) -16 AWG, WHITE (Neutral) -18 AWG, GREEN (Ground) - 18 AWG.
    • Environmental Requirements
      • Operating Temperature 32 to 120 degrees F
      • Operating Humidity 10% to 95% non-condensing
  • Leave a Review

    You're reviewing: ACT RD134W Wall Mount A10 Dimmer - White

    • 1 star
      2 stars
      3 stars
      4 stars
      5 stars

    * Required Fields

  • 1x - Wall Mount A10 Dimmer - White

Norton McAfee
place your order by 3pm PT for same day shipping

Please wait...

smarthome

Item has been added to your cart
smarthome

Item has been removed from your cart