1-12 of 34 Results in Best Seller Order
|
Compare up to 10 items now
|
View:
At A Glance
|
Detailed
Products Per Page:
12
|
24
|
48
1
|
2
|
3
|
>
|
|
Sort By:
|
|
|
Access Point - INSTEON Wireless Phase Coupler
|
|
AccessPoints allow RF-only INSTEON devices (like a RemoteLinc) to send commands to power line-only INSTEON devices (like a SwitchLinc). If you need more coverage for your INSTEON RF devices, you only need to add another AccessPoint.
More info...
|
|
|
Part #
2443
|
Compare
|
|
$39.99
|
|
|
FilterLinc 10-Amp Plug-In Noise Filter
|
|
Maximize the efficiency of your X10 system with the 10-Amp plug-in noise filter that includes a bonus feed-through outlet.
More info...
|
|
|
Part #
1626-10
|
Compare
|
|
$29.99
|
|
|
SignaLinc - INSTEON Phase Coupler, Hardwired
|
|
Improve INSTEON signal reliability and put an end to erratic X10 performance with this hardwired device that improves the signal strength on all AC lines in your home.
More info...
|
|
|
Part #
2406H
|
Compare
|
|
$24.99
|
|
|
SignaLinc Repeater 4-Wire Dryer
|
|
For years, the only way to get X10 signals to every outlet was to wire a coupler-repeater to the breaker box. Those days are history, with the 4-Pin SignaLinc Coupler-Repeater.
More info...
|
|
|
Part #
4826A
|
Compare
|
|
Sale $99.99
$119.99
|
|
|
SignaLinc Plug-In Phase Coupler (For 3-Wire 220v Dryers)
|
|
Increase X10 signal reliability simply by plugging in this phase coupler. No hardwiring required!
More info...
|
|
|
Part #
4816B2
|
Compare
|
|
Sale $29.99
$39.99
|
|
|
Leviton HCA02-10E 2-Phase X10 Coupler-Repeater
|
|
Increase X10 reliability AND make troubleshooting easier with an Amplified Coupler-Repeater that sends and receives test signals!
More info...
|
|
|
Part #
4823
|
Compare
|
|
Sale $76.34
$98.99
|
|
|
Leviton 6287 Noise Block
|
|
High Pressure Discharge lighting (HID) including Mercury, Sodium Vapor and Metal Halide types often generate a significant amount of noise when turned off. The noise usually turns the X10 fixture module back on immediately after it is turned off. This noise block will filter out that noise.
More info...
|
|
|
Part #
4835
|
Compare
|
|
Sale $25.61
$37.99
|
|
|
X10 PZZ01 Pro Whole-House X10 Blocking Coupler
|
|
Slip this whole-house blocking coupler over the neutral wire feed entering the house. It senses the presence of electrical noise and X10 signals, then it generates an offsetting voltage signal to attenuate the entering noise and X10 signals.
More info...
|
|
|
Part #
4851X
|
Compare
|
|
Sale $52.99
$59.99
|
|
|
Attenuator Pad Mix Bag (2 Ea. 3, 6,10 & 20 Db Pads)
|
|
Install in-line with coax cable and reduce signal strength by rated amount. Try different combinations until you get the best picture quality. Use to balance signal strength from different sources.
More info...
|
|
|
Part #
7800
|
Compare
|
|
Sale $6.99
$15.92
|
|
|
Leviton 6289 In-Line Noise Reducer
|
|
A filter that can be used with any load or installed near an X10 module that is being affected by powerline interference. Filters out electrical noise above and below the 121Khz X10 signal but allows the X10 signal to pass through.
More info...
|
|
|
Part #
4840
|
Compare
|
|
Sale $39.75
$56.99
|
|
|
HomePro CP000 X10 Signal Bridge
|
|
If X10 transmitters in one part of your home seem to be unable to control X10 devices in another part of your home, this signal bridge will most likely solve the problem.
More info...
|
|
|
Part #
4815AC
|
Compare
|
|
Sale $10.42
$12.25
|
|
|
Wire-In UPB Phase Coupler-Breaker Panel
|
|
Connect this universal phase coupler in your home's circuit breaker box, and it will bridge UPB as well as X10 signals between the two power lines in your home easily, allowing virtually all of your automation receivers to respond reliably to remote commands.
More info...
|
|
|
Part #
22934B
|
Compare
|
|
Sale $53.82
$69.99
|
|
|
|
1-12 of 34 Results in Best Seller Order
|
1
|
2
|
3
|
>
|
|