|
|
|
| Hidden Link IR Kit |
|
|
| Item# 8165 |
|
|
|
|
|
|
Overview
|
- Attractive case for shelf-top locations
- Red talkback LED tests system for correct wiring as well as indicating infrared reception
- Attached 7' cable and 3.5 mm mini plug permits direct plug-in to connecting blocks
Essential Info
Use this shelf-top IR receiver when you can't drill into a cabinet or piece of equipment to use the smaller hidden sensors. Xantech's Hidden Link sensor is about an inch high and about 3.25" wide and include a 'talkback' LED so you'll know the command was received and sent to the emitter. NOTE: The status LED on your IR repeater should only be lit when it is receiving an IR signal from your remote control. If you notice that the LED is always on, you may be getting interference from your television or the ambient light in the room. This will cause the system to overheat and will burn out prematurely. There are LCD and Plasma safe kits which filter out the interference coming from your television.
Manuals/Software
What's Included
One Tabletop IR Sensor #8110
Four Visible Blinking Stick-On IR Emitter #8160
One 1- Zone Connecting Block
One 12-Volt DC Power Supply 200MA
|
More Info
|
The Xantech IR Hidden Link Kit includes:
- 1 Tabletop IR Sensor (#8110). This table top sensor picks up IR signals up to 90 degrees and up to 30 feet away. Equipped with a 7-foot cable and 3.5 mm stereo mini plug, which is plugged directly into the "IR RCVR" jack on the included one-emitter connecting block or any connecting block we carry. IR modulation frequency bandwidth: 30 - 100 kHz.
- 4 Visible Blinking Stick-On IR Emitter (#8160). The #8160 is a single headed emitter that produces a blink when operating. This is helpful in troubleshooting an IR distribution and works well when the equipment is inside a cabinet where the blinking will not distract the user.
- 1 Zone Connecting Block. The One Zone Connecting Block collects signals from room IR sensors, processes them and sends the signals to your audio/video equipment via an infrared emitter. Connects four emitter ports and power supply to all Xantech infrared receivers and keypads.
- 1 12-Volt DC Power Supply 200MA. Standard 12-Volt DC power supply for the one zone connecting block.
|
Specifications
|
Specifications | | Manufacturer: | Xantech | | Manufacturer Product No.: | 291-KIT/RP |
|
Reviews
|
|
|
Related Items
|
|
|
|
|