• 4 Pairs of Beams, 43" (109cm), Up to 380ft (120m) range
• For indoor or outdoor perimeter security
• Install on windows, doorways, skylights, fence tops, and any place where space is limited
• End caps swivel so sensor can be mounted on single or on opposite walls with no L-bracket needed
• Programmable trigger
• Heater for use in cold weather operation
• Heater activates at 41ºF (5ºC)
• Terminal block wiring

ENFORCER Long-Range Barrier Sensors are ideal for protecting indoor or outdoor areas separated by long distances. They feature reliable photobeam technology with a choice of four programmable beam frequencies that provide superior perimeter protection by eliminating crosstalk and interference when multiple units are used. False alarms caused by animals, falling leaves, poor weather, or other sources are minimized by programming the alarm output trigger operation.

ENFORCER Long-Range Barrier Sensors work in even the most extreme conditions. A built-in heater automatically turns on and off depending on the outside temperature. An environmental control system senses a slow degradation in beam strength when weather conditions worsen to help prevent false alarms.

Installation and alignment is quick and easy with the ENFORCER Long-Range Barrier Sensors. They come with swiveling heads that allow them to be mounted along the same wall or on opposite walls, as well as provide for easy alignment of the beams between the transmitter and receiver.

Additional Features

Slim design: 2-1/4" x 1-7/8" (55 x 49 mm)

Rugged aluminum construction

Built-in tamper switches, one on either end, trigger the alarm if end cap is removed

No synchronizing wires required to align the beams

Form C relay output

LED and buzzer alignment indicators

AGC (Auto Gain Control) circuits regulate beam signals in order to compensate for and ensure operation in rain, fog, and

low-temperature conditions

Programmable for 4 different frequencies to reduce interference between multiple units

• Owner's Manual

1x - Transmitter

1x - Receiver

1x - Manual

4x - Pole mount brackets

8x - Machine screws 4x6mm (for pole mount brackets)

8x - Machine screws 4x25mm (for pole mount brackets)

12x - Screws 6x20mm (for wall mount use)

12x - Plastic anchors (for wall mount use)

SECO-LARM Enforcer E-9661-6B190Q Indoor/Outdoor Long-Range Barrier Sensors, 6-Pairs of Beams	Enforcer Quad Photobeam Detector, 330 Foot Range	SECO-LARM E-960-D290Q Enforcer Twin Photobeam Detectors with Laser Beam Alignment, 290 Foot Range