|
|
| 200 Series Universal Wireless Trsmtr |
| Item# 7400 |
|
|
|
|
|
Overview
|
- The convenience of wireless sensors with your existing hardwired security system
- Place security sensors without running more wire!
- Transmit a NO or NC dry contact signal up to 200' to a receiver
- Transmit to one or more of 4 channels simultaneously upon alarm in any combination
Essential Info
The WT-100 is a general purpose, battery powered single-input transmitter for use with Normally Open (N.O.) and Normally Closed (N.C.) sensors and inertial vibration detectors. The transmitters signals are designed to work with the 200 series wireless receivers: 4-Channel (#7410)
2-Channel (#7411)
1-Channel (#7412)
A built in reed switch can be used with a magnet (not supplied) to protect a door or a window. An on-board tamper switch triggers a tamper alert (Channel 2) if the front cover is removed from the base.
Manuals/Software
What's Included
200 Series Universal Transmitter WT-100
Battery
|
More Info
|
A special timing circuit saves the 9-volt battery power by limiting the transmitting time.
When the WT-100 is triggered, it transmits for about 2 seconds, then inhibits itself for
approximately one minute. If an input remains disturbed, the WT-100 will keep
transmitting signals for a 2-second duration each minute, until the input reverts to the
undisturbed state. The WT-100A is a single-shot (non-repeating) model that transmits
only once upon each input trigger.
The LED lights during the transmission period. A special circuit continuously monitors
the battery voltage. If this drops below about 7.5 Volts, the transmitter automatically
transmits a low battery alert signal for 1-2 seconds, to activate a buzzer in the target
receiver. Low battery signals are repeated at one-minute intervals for a few days,
depending on the remaining amount of battery energy. The LED lights during each
transmission, identifying the unit transmitting the low battery signal.
Sensor will be connected between the Bat (-) and the N.O. or N.C. terminals, depending upon whether the sensor is normally open (N.O) or normally closed (N.C.)
|
Specifications
|
Specifications | | Visonic Product No.: | WT-100 | | Compatibility: | Works with any sensor with NO or NC connection | | Dimensions: | 2 1/2" x 4 1/4" x 1" | | Power Supply: | Alkaline battery (included) |
|
Images/Video
|
|
|
Reviews
|
|
|
Accessories
|
|
|
Related Items
|
Customers Also Bought
|
|
|
|