• Control 220V devices as part of an INSTEON, X10, UPB, ZWave or ZigBee network
• 110 VAC Plug Cord for Energizing the Relay Coil
• Heavy Duty "Lockable" Metal Enclosure
• Pre-Wired Terminal Lugs for easy Installation
• Safe and easy On/Off switching of up to 60 Amps of electrical current
• Relay Suitable for a 110 VAC or 220 VAC Load

The ELK-9200 is a Heavy Duty Relay/Contactor inside a lockable metal enclosure. It is designed for remotely controlling high current devices such as electric water heaters, pumps, motors, gates, etc. The energizing coil of the 9200 is 110 VAC, however its relay contacts are capable of switching 220 VAC at up to 60 Amps of current. The relay coil is prewired with a three prong plug-in cord that is compatible with virtually any appliance style automation module (purchased separately) including: INSTEON, UPB, ZWave, Zigbee, X10, etc. A simple remote command can be sent to activate the lower current automation module, which in turn then activates the higher current contacts of the 9200 relay. This permits the safe and easy On/Off switching of up to 60 Amps of electrical current.

Please note: It is recommended to mount this enclosure in a dry indoor location. Additionally, approved electrical wire clamps (not included) should be used when running wire from the load device and the electrical panel into the wiring panel.

• Installation Guide

1x - Heavy Duty Relay Contactor in a Lockable Metal Structured Wiring Panel Enclosure

1x - Installation Guide

Elk Security	INSTEON Products	ELK Multipurpose Enclosure to House M1EZ8	INSTEON 240V 30 AMP Load Controller Normally Closed Relay (Dual-Band)

ApplianceLinc - INSTEON Plug-in Appliance On/Off Module, 3-Pin	SwitchLinc Dimmer - INSTEON Remote Control Dimmer (Dual-Band), White	SwitchLinc On/Off - INSTEON Remote Control Switch (Dual-Band), White	I/O Linc - INSTEON Low Voltage / Contact Closure Interface ( 1 In / 1 Out )