|
|
| Minotaur Engineering WSI1 Water/ Moisture Sensor for INSTEON I/O Linc |
|
Item# 71940
|
|
|
Price: $48.00
|
|
|
|
|
|
Free shipping on orders $200 and up details
|
|
Overview
|
- Sensor detects moisture or leaks using 2 probes
- Water sensor sends signal to INSTEON I/O Linc unit
- Only one I/O Linc is needed for multiple water sensors
Essential Info
Catch leaks as soon as they start with a water-sensor system that triggers I/O Linc-connected lamps to flash. The INSTEON Water/Moisture Sensor can detect moisture on any non-conductive surface and send a signal to any INSTEON receiver in range via an I/O Linc (sold separately). This product is also available with audio alert.
Important notes:
- Smarthome offers technical support on this product. We offer (2) ways to contact us for technical support: CHAT (homepage button: Mon-Fri 9:00am-6:00pm ET) or Phone: 1-800-762-7846 (Mon-Fri 9:00am-9:00pm & Sat 10:00am-4:00pm ET)
- Defective exchanges for identical item within Manufacturer’s warranty period.
Manuals/Software
What's Included
Sensor
Self-adhesive wire tie and holder
Instructions
|
More Info
|
The Water/ Moisture Sensor for INSTEON I/O Linc connects to the I/O Linc unit via three leads on a 5-foot cable. The sensor should be placed such that the two probes firmly touch the surface to be protected. It is recommended that the use of the enclosed self adhesive wire tie and holder to correctly position the sensor and hold it in place. Care should be taken such that the sensor is in a position so that if moisture occurs in the area, it does not "run" or drip away from the sensor.
1) Plug your I/O Linc into an un-switched outlet near your Water Sensor. (The I/O Linc LED will come on.)
2) Place the sensor such that the two screw "legs" are on a common wet surface.
3) Press and hold the I/O Linc Set button until it beeps (about 3 seconds.)
4) Plug in your INSTEON Responder (receiver) in to an un-switched wall outlet.
5) Now Press and hold the Set button on your INSTEON Responder (the device you wish to control) for at least 3 seconds. (The I/O Linc will beep and its Status LED will return to steady "on" to confirm linking.)
6) Plug devices you wish to control in to your INSTEON Responder unit as required.
7) Test the water sensor by removing and replacing the unit on the wet surface. Controlled devices will turn on and off respectively.
8) Attach the wire tie and holder to the surface and verify that the wire cannot inadvertently injure anyone. Placing the sensor on a wet wash cloth will trigger the unit and allow a user to test the system.
|
Specifications
|
Specifications | | Minotaur Engineering Product No.: | WSI1 | | Dimensions: | 1 5/16" diameter x 1 1/4" H | | Cord: | 5' (approx) |
|
Reviews
|
|
|
Related Items
|
Customers Also Bought
|
|
|
|