Add $175.00 for FREE shipping
Shop All!
Wall Switches, Keypads & Touchscreens Type
Wall Switches & Dimmers
Control Type
Zwave Controllable
Load Type
Electronic Low Voltage
Incandescent / Halogen
Magnetic Low Voltage
Z-Wave Compatible
2-Way Communication
Adjustable On Levels
Adjustable Ramp Rates
LED Feedback
Multi-Way Ready
Trim Plate Design
Decora / Paddle
Ease of Installation
Intermediate (Installs < 60 minutes)
Other Ways to Shop
In Stock
On Sale
Order the Smarthome Catalog

Enables Wireless Control of On/Off and Dim Functions
Z-Wave Wireless Lighting Control Three-Way Dimmer Kit
Z-Wave Wireless Lighting Control Three-Way Dimmer Kit
Z-Wave Wireless Lighting Control Three-Way Dimmer Kit
Item# 5943
Price: Normally $79.99 
Hot Deal $52.82
Free shipping on orders over $175 - See Details


  • Wirelessly control on/off and dim functions of incandescent lighting from two places
  • Kit includes primary dimmer switch and auxiliary switch for control of one light from two locations
  • Provides Z-Wave wireless and manual control
  • LED indicator light allows easy location of primary switch in dark room
  • Easily connects using existing wires

Essential Info

The GE 3-Way Dimmer Kit enables wireless control of on/off and dim functions of hard-wired incandescent lighting, and includes a primary and auxiliary switch for control of one light from two locations. The dimmer switches replace your current light switches, use your existing wiring, and provide Z-Wave wireless and manual control of overhead lighting. The primary dimmer switch includes an LED indicator light to easily locate the switch in a dark room.

The auxiliary switch is not Z-Wave enabled and does not directly control electrical loads. It must be used with a compatible Z-Wave enabled, 3-wire switch in three-way installations where a light is controlled from 2 locations such as the top and bottom of a staircase. This switch communicates with the Z-Wave enabled switch, providing manual On/Off/Dim control of the connected lighting (through the Z-Wave enabled switch) and synchronization of the lighting status (On/Off/Dim level) between the two switches.

Important Note:Not for use with fluorescent lights or motors.


What's Included

  • 1x - Primary Switch
  • 1x - Auxiliary Switch
  • 1x - Installation Instructions

  • Specifications

    Manufacturer Product No476TM-524
    Power 120VAC, 60Hz
    Signal (Frequency)908.42 MHz
    Minimum Load400W, incandescent lamps only
    Maximum Load500W, incandescent lamps only
    RangeUp to 65 feet line of sight between the Wireless Controller and the closest Z-Wave receive module
    Operating Temperature Range32°F - 104°F (0 - 40°C)
    Important notes:
    Defective exchanges for identical item within 30 days of purchase. After 30 days, please contact the manufacturer.
    Manufacturer contact information: Jasco Products Co, Tel: (800) 654-8483 Ext #1


    11 Ratings
    5 star: 45%  (5)
    4 star: 9%  (1)
    3 star: 9%  (1)
    2 star: 18%  (2)
    1 star: 18%  (2)
    Average Customer Rating
    (11 customer ratings)
    Share your thoughts with other customers
    DRAKE -- springfield, OH   1/13/2014
    Easy to install and use. Nice features. Negative: When remote programming of dim level is used to change level of already "on" lights, a noticeable flicker occurs
    CODY -- amarillo, TX   4/21/2013
    They go in and off fine. When using the dimming feature the lights blink and flicker. It still works. Just a little annoying
    Tim -- dallas, TX, United States   2/25/2012
    These switches are NOT compatible with dimmable LEDs such as the CREE or EcoSmart 6 recessed can replacements. These switches cannot hold the voltage steady with the low current draw of LED lights and will cause the lights to flicker, even at 100% brightness. If you have 4 or more LEDs on a single circuit, they may be steady depending on brands. GE/Jasco will not accept this as a faulty dimming mechanism and will not repair or replace the devices. With the new US energy laws restricting incandescent bulb usage, if you purchase these switches now for your home and replace your lights with LEDs or any low wattage device, you will need to purchase new dimming switches. Investigate the higher cost Electronic Low Voltage ELV dimmers on the market if you are going green.
    MICHAEL -- lilburn, GA   1/23/2012
    Works great. The blue led is a nice touch. You can disable this if you want. You need to be aware that the master needs a neutral line to work. This will require a little home wiring knowlege. It must need the power to transmit the Z-wave signal.
    PAULO -- santo andre, XX   9/12/2011
    Works great with the MCV Vera 2.
    CYNTHIA -- wilton, CT   7/1/2011
    won't work with the wiring set-up in my house...spent 4 hours discovering this... very disappointed
    Wes -- calgary, AB, Canada   3/26/2011
    I really like the GE zwave lights. I've purchased a whole set of them for my basement development. Unfortunately, they do seem to have quality control issues. I've ordered around 15 sets of dimmers and 3-ways, and I've had 2 sets of the 3-ways arrive DOA. And I've had one regular dimmer also arrive DOA. The ones that work seem to still be working, but we'll see for how long!
    AARON -- bloomington, IL   10/14/2010
    They work "as advertised". It seems to be built kind of 'cheap' though; I hope it lasts.

    Related Items

    Customers Also Bought

    Sign-up for Exclusive Email offers 
    How to Order Track Your Package Shipping Returns Contact Us Customer Service Retail Store
    Getting Started Learning Center FAQ Dealers Customer Testimonials Affiliate Program
    About Us INSTEON Press Awards Employment Guarantees Security & Privacy
    Free Catalog Email Newsletter Forum RSS Site Map
    Have questions? Call us at 800-762-7846 (Mon-Fri 5am-7pm and Sat 6am-3pm PT) or send us a message
    Place your order by 3pm PT for same day shipping
    Copyright 1995-2014 SMARTHOME™
    Verisign Secure Site PayPal Acceptance Mark