Overview
|
- Isolates noisy devices from the powerline
- For loads up to 5A
- Measures 1 7/8" x 1 9/16" x 3/4"
Essential Info
This small unit will filter up to five amps of 120-volt electricity. Install this filter between a noisy electrical device and the AC lines. The unit, when installed close to the noise-generating device, will prevent electrical line noise pollution for the rest of the house. It is most commonly needed on High Pressure Discharge lighting (HID) and fixtures with electronic low-voltage transformers. Some fluorescent light ballast transformers can also produce noise.
Manuals/Software
What's Included
Leviton Noise Block 6287
|
More Info
|
Use this filter with X10 receivers to fix bothersome problems. If you can turn on an X10 device remotely, but not turn it off, then this filter will help. When the device is on, (and generating noise), the X10 receiver can't "see" the X10 off signal because of the noise. When the device is off, there is no noise, so the command is easily recognized on the AC lines. Install this filter as close to the noise generator as possible. It needs to be installed between the X10 receiver and the device being controlled. Please note that the filter will NOT WORK for two wire wall switches that do not have a neutral wire. If installed on two-wire switches, it will also filter out X10 signals. See the wiring diagram on the right for more information.
Install this unit when installing HID lighting to prevent erratic operation. High Pressure Discharge lighting (HID) often generates a significant amount of noise when turned off. The noise usually turns the X10 module back on immediately after it is turned off. If the X10 module chatters then turning on HID lighting, this filter will alleviate the problem.
|
Specifications
|
Specifications | | Manufacturer: | Leviton | | Manufacturer Product No.: | 6287 | | Compatibility: | X10 | | Dimensions: | 1 7/8 in. x 1 9/16 in. x 3/4 in. |
|
Reviews
|
|
|
Related Items
|
Customers Also Bought
|
|
View Cart 
