 |
 The Easiest Way to Increase X10 Signal Reliability! |
|
SignaLinc� Plug-In Phase Coupler
|
|
Solve signal reception problems instantly with the world's first plug-in phase coupler.
Full Size Image
|
- Plugs right into a 220V outlet — no hardwiring involved
- Built-in receptacle — you won't tie up the outlet
- Stays hidden behind your dryer
- Now with a new, improved look
|
|
Having trouble getting X10 receivers in one area of your home to operate from X10 transmitters in another area of your home? Solve the problem in seconds with the SignaLinc, the world's first Plug-In Phase Coupler!
Because most homes have 2-phase 220V power that splits into two separate 110V legs, sometimes X10 signals have a hard time making the transition from one leg to the other. But simply plug a SignaLinc into one of your home's 220V receptacles (like the one powering your electric dryer) and it will pass X10 signals between the two power lines in your home.
Unlike previous solutions, which could involve hiring an electrician to hardwire a signal bridge or jury-rigging a capacitor inside the breaker box, the SignaLinc can be installed just by plugging it in! Plus, with its built-in receptacle, you'll be able to do this without blocking other appliances from plugging into it. The SignaLinc for 4-wire dryers (#4816A2) and 3-wire dryers (#4816B2) remain easily hidden behind the dryer (measures 3.13" wide, 4.31" high, 2.92" deep [4.34" deep with AC prongs]). The SignaLinc for 3-wire general appliances (#4816C) is mounted on the end of a 6-ft. power cable.
Note: The SignaLinc� is a passive coupler and does not amplify the signal. This means the signal coupled onto the receiving phase will be no stronger than the original signal on the transmitting phase. How well the SignaLinc� works in your home is dependent on many factors, including signal strength for the transmission phase. For homes larger than 3,000 sq. ft., we recommend installing an amplified coupler repeater.
 The SignaLinc� has been tested, investigated and found to comply with the requirements of the Standard(s) for Information Technology Equipment (UL-1950) and are identified with the ETL Listed Mark. The product with this mark on it has been certified by Intertek Testing Services (ITS). This certification mark indicates that the product has been tested to and has met the minimum requirements of a widely recognized (consensus) U.S. product safety standard, that the manufacturing site has been audited, and that the applicant has agreed to a program of periodic factory follow-up inspections to verify continued conformance.
Safety Tested and Factory Certification
All SignaLinc products are safety approved. The assembly line for Smarthome Design Products is ISO9002 certified. In order to meet the ISO 9002 standards, the entire factory underwent rigorous inspections of procedures and policies before being thoroughly audited. The certification received was based on its dedication to high quality management systems and strict adherence of quality systems and guidelines
Increase your warranty from 2 to 7 years for only a fraction of the purchase price. Select item numbers below ending in WR or WAR where it is offered.
|
Email page to a Friend
