- What's Included
Watch or tape from up to four separate sources, switching among them either manually or with the included remote control. This unit allows any of four audio and/or video sources with Y, Cb, Cr, or Y, Pb, Pr outputs (component) to be switched to the output jacks.
This switch is housed in a full metal cabinet that has the weight to stay on the table even with all of the cables connected. High bandwidth and extremely low crosstalk provide maximum picture performance, and the switch is DC coupled for extremely fast, rock-solid performance with no sync drop-outs.
Manufacturer: Cable Electronics Manufacturer Product No.: SW104HD Dimensions: 11.7" x 6.3" x 1.75" Weight: 3 lbs. Power Requirements: External 9 to 10 volt AC @ 500mA with a 2.1mm coax connector Warranty: 1 year, limited
Nominal Input Level: 1 volt peak to peak Gain: 1 volt into 75 ohms (2 volts unterminated) Input Impedance: 75 ohms Output Impedance: 75 ohms Port to Port Isolation: >50 dB On to Off Isolation: >60 dB Return Loss: >18 dB Video Bandwidth: >100 MHz (HDTV requires 37 MHz minimum)
Nominal Input Level: 1 volt peak to peak Gain: Unity (one to one) Input Impedance: 22k ohm Output Impedance: 1k ohm THD: 0.05% Frequency Response: 20Hz to 100kHz Channel Separation: >75 dB Port to Port Isolation: >50 dB Out to Input Isolation: 60 dB Signal to Noise: 100 dB @ 2 volts out
Leave a Review
- 2 AA batteries
- Power supply