This EZIO6I by SimpleHomeNet allows virtually any
sensor connected to one of the six inputs on the interface module to send out a signal or group command to
INSTEON devices. You can detect and monitor external events by using a smoke detector to have all the lights in the house flash when triggered, or a temperature sensor to activate your thermostat when the temperature gets too high or too low, the applications are virtually endless. You can create timers that send commands after a pre-set amount of time, from 1 second to 255 minutes, and change the behavior of the inputs relative to INSTEON commands that are sent, the group, number, the order of commands, etc. The EZIO6I works with several home automation software programs such as
mControl,
Homeseer and
Indigo, each sold separately. Alternatively, you can use a free
SimpleHomeNet Utility Suite software to setup your device. The interface module is a plug-in device, so you can eliminate long run wiring complications by simply plugging the device in at the closest point to your sensors.
While all the basic functions can be programmed manually, there are advanced programming options that you can achieve with the
EZSrve, central automation controller. If you already have a central automation controller or a software package for your INSTEON network that doesn't have the correct parameters to program the advanced functionality of this device, you can download the free
Simplehomenet Utility Suite which works in conjunction with an
INSTEON Powerlinc Controller. (Note: The Simplehomenet Utility does not interface with the INSTEON Powerlinc Modem.)