Holds RemoteLinc 2 very loosely and moves when pressing the remote button. This happens when mounting to the back of a wall plate instead of directly to the wall.

The small configurable remotes are wonderful and this mounting bracket supports maximum flexibility.

Glad that you don't need to cut holes in the wall, can just attach with two screws.

Works fine.

Part of a slowly expanding installation, these units were easy to install and set up. New users should ensure that they have a neutral wire and space for an InLineLinc before ordering (I checked and did) but otherwise these are a simple installation. In this particular case, the InLineLinc, the RemoteLinc, and the bracket were used to install a wall switch in a room that previously only had a pull-string light. Much nicer to have the wall switch – and even better not to have to pay for pulling cable. The control systems aspect was an added benefit. On the down side, the RemoteLinc switches have a markedly different look and feel from the SwitchLinc and/or standard switches. If your installation includes ganging the devices, know in advance that they won’t look ‘perfect’ and the different feel will be highlighted every time you operate the switches.

Works great - again, good fit and finish.

It does the job, although the fit is a bit loose and the RemoteLinc jiggles around in the bracket.

This product doesn't work to hold the RemoteLinc. As mentioned in one of the other reviews, it is loose and jiggles around when touched. In my case, it couldn't even get the RemoteLinc to stay in the bracket. With any kind of pressure, the RemoteLinc pops through into the electrical box. I know it says be careful not to overtighten the screws, which I was. I'm going to have to glue a piece of wood over the back of the bracket to prevent it from falling through. I really don't like reaching into an electrical box!

I created a wireless 3-way lighting circuit in my room using a SwitchLinc Dimmer 2477D, RemoteLinc Switch and this wall mount bracket. I used the Aspire screwless trim plate to finish it off and it now looks like I ran wire to the other side of my room. The bonus of being able to pop the RemoteLinc out of the mount and carry it to the bedside is awesome.

Pretty bad for such a simple product. 1. The bumps that are supposed to hold the RemoteLinc2 barely do, it sits rather loose in the frame and will rattle on the wall once installed. 2. The drywall anchors included are cheap and will snap in half if not carefully put in the wall. 3. The screws themselves that go into the drywall anchor are actually too small on their head to hold the frame securely, they WILL pop through. Overall, I know this is a cheap part Though at over 5 bucks I'd have to say its a pretty big premium for what is a piece of plastic and two screws but it should be better than this. NOT RECOMMENDED