• Easily wires in to protect entire circuits
• Blocks noise above 4 kHz
• Compatible with all power line technologies

With all the electrical devices found in the average American home, electrical noise and signal attenuation of home automation signals can become a major concern. Excess traffic on the power line, caused by HID lighting, motor devices, switching power supplies and other devices that run at frequencies between 4 and 40 kHz, make it harder for signals to travel. Larger and highly capacitive devices, such as televisions, computer equipment, and universal power supplies (UPSs) might absorb the signal completely so may not reach its intended receiver. Interference with your UPB signals could greatly reduce the efficiency and reliability of your UPB system. By installing this Simply Automated noise filter between the UPB device and the noise-producing device, you will ensure the UPB signal transmissions will not be slowed down or lost. This noise filter is designed to block any electrical noise above 4 kHz and works with all power line technologies. Installation is so hassle-free, it will only take a few minutes to maintain and significantly improve your UPB systems reliability.

This product is also available in a plug-in version, sold separately.

• Smarthome does not offer technical support on this product, please contact the manufacturer directly for all product support.
• Only defective exchanges for identical item within 30 days of purchase. No other returns allowed on this item. For defective returns after 30 days, please contact the manufacturer.

• Owner's Manual

1x - Wired-In Noise Filter/Attenuation Isolator

Simply Automated Noise Filter/Attenuation Isolator, Plug-In	20-Amp 3-Wire Noise Filter	Leviton Noise Block	ACT 20-Amp Low-Pass Filter
ACT 120-277 VAC Two-Wire Low Pass Filter